HCIA and HCIP Sample Questions | Generated by AI
Question: Provide a set of sample exam questions for HCIA (Huawei Certified ICT Associate) and HCIP (Huawei Certified ICT Professional) level certifications, without revealing the answers.
Answer:
HCIA-Level Sample Questions (Mostly HCIA-Routing & Switching, HCIA-Datacom, HCIA-Storage, etc.)
- What is the default administrative distance of OSPF routes in Huawei routers?
- In Huawei switches, which command is used to configure a VLAN as a super VLAN?
- What is the default priority value of a Huawei device when electing the root bridge in STP?
- Which protocol is used by VRRP to elect the master router?
- In Huawei eSight, which module is primarily responsible for managing WLAN devices?
- What is the maximum number of equal-cost routes supported by default in Huawei IS-IS?
- Which command displays the current ARP table on a Huawei router?
- In HCIA-Storage, what does RAID-DP stand for, and on which Huawei storage products is it commonly used?
- Which Huawei firewall zone has the highest default security level?
- What is the default lease time for DHCP addresses on Huawei routers?
HCIP-Level Sample Questions (Mostly HCIP-Routing & Switching, HCIP-Datacom)
- When configuring BGP on Huawei routers, which command can be used to filter routes advertised to a specific peer using a route-policy?
- In a Huawei VXLAN environment, after configuring VTEP, which command verifies the VXLAN tunnel status?
- How does Huawei’s NetStream differ from traditional IP FPM in terms of sampling methods?
- In HCIP-Carrier IP, what is the purpose of the “mpls te cspf” command in an MPLS TE tunnel configuration?
- When troubleshooting iMaster NCE-Campus, a network administrator notices that the “BFD session state is Down” between two devices. Which three possible causes should be checked first?
- In Huawei’s SDN solution, which protocol does the NetConf interface primarily use for configuration delivery?
- Describe the differences between policy-based routing (PBR) and QoS-based routing on Huawei NE-series routers.
- In an HCIP-Security scenario, how would you configure a Huawei USG firewall to implement virtual systems (VSYS) and assign different physical interfaces to different virtual firewalls?
- When configuring Segment Routing IPv6 (SRv6) on Huawei NE routers, which command enables SRv6 capability on an interface?
- In a large-scale EVPN VXLAN fabric, explain how Huawei devices handle MAC address learning and withdrawal in distributed gateway mode versus centralized gateway mode.
These questions are styled after real HCIA/HCIP exam questions (multiple-choice, single-answer, multi-answer, and short explanation types) but without any answers or options provided. Good luck with your preparation!